Dipole Antenna Halyard Arm for 25G Type Tower Section

Description

Description
This halyard arm is designed to provide a convenient method for raising and lowering of dipole antennas.
It is constructed from 6061 T6 aluminum resulting in a strong, light weight corrosion resistant item.
T
he halyard arm has a 1-1/2 inch diameter pulley to reduce the effort required when raising a dipole antenna.
Once installed, the halyard line is held captive by the pulley assembly.
There is no need to worry about the line getting pinched by the pulley.
Further, it can support a 35 pound dipole assembly with accreted ice load on the dipole wires, coaxial cable and halyard.
Specifications
Over-all Length:
36 inch (plus or minus 1 inch)
Tubing Width and Height:
2 inches (outside measurements)
Tubing Material:
6061 T-6 aluminum
Load Bearing Capacity
:
35
pounds (plus ice load)
Attaching Hardware:
Two 5/16 inch coarse threaded (18 TPI) U-bolts
U-bolt Torque:
8 foot/lbs (96 inch/lbs) maximum
Pulley Diameter:
1-1/2 inches
Weight:
3.8 pounds (without halyard line)
Halyard Line Diameter:
3/16 inch diameter (maximum)
Halyard Line:
Any weather resistant line.
3/16 inch wire rope may be used; but, it is not recommended.